DS1775R7+T&R【PDF 2/14 页】IC THERMOM/STAT DIG 111 SOT-23-5

收藏本站

您好，
买卖IC网欢迎您。
请登录
免费注册

买卖IC网

Sheet目录39

1页 [2页]3页 4页 5页 6页

DS1775

2 of 14

Table 1. Detailed Pin Description

NAME

FUNCTION

SCL

Clock Input/Output for 2-Wire Serial Communication Port. This input should

be tied to GND for stand-alone thermostat o eration.

GND

Ground

O.S.

Thermostat Output. Open-drain output becomes active when temperature

exceeds T

. Device configuration defines means to clear overtemperature

state.

Su l Volta e 2.7V to 5.5V In ut Power Pin

SDA

Data Input/Output for 2-Wire Serial Communication Port. In the stand-alone

thermostat mode this in ut selects h steresis.

DETAILED DESCRIPTION

Figure 1 shows a block diagram of the DS1775. The DS1775 consists of five major components:

1. Precision temperature sensor

2. Analog-to-digital converter

3. 2-wire interface electronics

4. Data registers

5. Thermostat comparator

The factory-calibrated temperature sensor requires no external components. Upon power-up, the DS1775

begins temperature conversions with the default resolution of 9 bits (0.5癈 resolution). The host can

periodically read the value in the temperature register, which contains the last completed conversion. As

conversions are performed in the background, reading the temperature register does not affect the

conversion in progress.

In power-sensitive applications, the user can put the DS1775 into a shutdown mode, under which the

sensor complete and store the conversion in progress and revert to a low-power standby state. In

applications where small incremental temperature changes are critical, the user can change the conversion

resolution from 9 bits to 10, 11, or 12. Each additional bit of resolution approximately doubles the

conversion time. This is accomplished by programming the configuration register. The configuration

thermostat output, number of consecutive faults to trigger an alarm condition, and the method to

terminate an alarm condition.

The user can also program overtemperature (T

) and undertemperature (T

HYST

) setpoints for thermostatic

operation. The power-up state of T

is +80癈 and that for T

HYST

is +75癈. The result of each

temperature conversion is compared with the T

and T

HYST

setpoints. The DS1775 offers two modes for

temperature control, the comparator mode and the interrupt mode. This allows the user the flexibility to

customize the condition that would generate and clear a fault condition. Regardless of the mode chosen,

the O.S. output becomes active only after the measured temperature exceeds the respective trip-point a

consecutive number of times; the number of consecutive conversions beyond the limit to generate an O.S.

is programmable. The power-up state of the DS1775 is in the comparator mode with a single fault

generating an active O.S.

Digital data is written to/read from the DS1775 via a 2-wire interface, and all communication is MSb

first.

发布紧急采购，3分钟左右您将得到回复。

采购需求

(若只采购一条型号，填写一行即可)

*型号	*数量	厂商	批号	封装

添加更多采购

采购需求

发布成功！您可以继续发布采购。也可以进入我的后台，查看报价

发布成功！您可以继续发布采购。也可以进入我的后台，查看报价

我的联系方式